With the increasing use of honing tubes, the quality of their products is becoming more and more uneven. The honing tube is an important equipment component. In addition to the quality of the material that can affect its service life, daily maintenance also improves it. Work efficiency is an important measure to increase its service life.

After 　　 honing tube is used for a period of time, some minor faults usually appear. Once they are ignored, minor problems will become major problems. Since the main working part of the honing tube is the piston and the cylinder part, the piston and the cylinder part are prone to problems, so the maintenance of this part becomes very important. The common problems in this part are the scratches of the piston rod and the abrasion of the cylinder. Once there is a problem in this part, the normal operation of the honing tube is difficult to carry out, so timely inspection and repair are required. If the honing pipe makes some strange noises when it is working, it means that there is a problem in the cylinder and it needs to be solved in time.

　　 In addition, when the honing tube is working, part of the mechanical energy is converted into heat, so the user needs to check the change of the oil temperature in time. Because the initial movement of the piston of the honing tube is difficult, the piston of the honing tube should be allowed to run freely for a short period of time without load when operating the machine. The main operating medium in the honing pipe is liquid oil, so it is required to keep the liquid oil clean.

　　 The normal operation of the honing pipe requires normal maintenance by humans. When using it, you should read the manual carefully and understand it before using it.

　　How to improve the finish of the honing tube

　　A kind of steel pipe obtained by honing process is called honing pipe. In the honing process of honing tubes, the use of honing tools is more common, and one of the more commonly used ones is honing gears.

　　 honing gear is made up of matrix plus abrasive. It is used for honing, mainly to clean up impurities and burrs on the surface of the material, thereby improving the surface finish. However, when we use this kind of honing tool, we also need to pay attention to the following points:

　　 1. The stroke of the equipment should not exceed the width range during honing, otherwise, the honing gear may be seriously damaged.

　　2. In the control of honing amount, the value should be controlled within a reasonable range. And for the control of the honing time, the same requirement is also required, and the suggestion is about two minutes.

　　3. The material of the honing gear is relatively brittle, so it is strictly forbidden to hit it, so as not to damage it and make it unusable.

　　 Regarding the question of how to improve the surface finish of the honing tube, it is not difficult to achieve the goal, because the honing process can be started and then realized. Furthermore, by selecting a suitable honing stone and controlling the roughness to be within the normal allowable range, the above requirements can be met. However, in some cases, it is still necessary to pay attention to the material used for the honing tube and the hardness of the material, so that it can be considered comprehensively to avoid problems.

　　 A brief introduction to the honing tool of the honing tube, as well as the guidance of its finish, I hope everyone can benefit from it and come to understand the product further. At the same time, these are also the theoretical basis for our future research work.